The Arduino subpackage is a collection of drivers for controlling peripherals attached to a Arduino port.
An Arduino connector can be used to connect to Arduino compatible shields to PL pins. Remember that appropriate controllers must be implemented in an overlay and connected to the corresponding pins before a shield can be used. Arduino pins can also be used as general purpose pins to connect to custom hardware using wires.
An Arduino PYNQ MicroBlaze is available to control the Arduino interface, if provided. The Arduino PYNQ MicroBlaze is similar to the Pmod PYNQ MicroBlaze, with more AXI Controllers.
As indicated in the diagram, the Arduino PYNQ MicroBlaze has a PYNQ MicroBlaze Subsystem, a configurable switch, and the following AXI controllers:
- AXI I2C
- Frequency: 100KHz
- Address mode: 7 bit
- 2x AXI SPI
- Master mode
- Transaction Width: 8
- SCK Frequency: 6.25 MHz
- FIFO Depth: 16
One SPI controller is connected to the Arduino interface dedicated SPI pins.
- 3x AXI GPIO
- 16 Input/Output pins total
- 6x AXI Timer
- 32 bits
- 1 Generate Output
- 1 PWM Output
- 1x AXI UART
- 9600 Baud
- 1x AXI XADC
- 1V peak-to-peak *
Analog inputs are supported via the internal Xilinx XADC. This supports inputs of 1V peak-to-peak. Note that the Arduino interface supports 0-5V analog inputs which is not supported by Zynq without external circuitry.
AXI Interrupt controller
Manages the interrupts of peripherals in the MicroBlaze subsystem.
An additional AXI GPIO is used to signal interrupt requests to the PS
Allows routing of signals from dedicated peripherals to the external interface.
|SPI*||D10 - D13|
|PWM||D3, D5, D6, D9, D10, D11|
|Timer||D3 - D6 and D8 - D11|
In the Base Overlay, one Arduino PYNQ MicroBlaze instance is available. After the overlay is loaded this instance can be accessed as follows:
from pynq.overlays.base import BaseOverlay from pynq.lib.arduino import Arduino_LCD18 lcd = Arduino_LCD18(base.ARDUINO) lcd.clear()
More information about the Arduino subpackage, its components, and its API can be found in the pynq.lib.arduino Package section.
For more examples, see the notebooks in the following directory on the PYNQ-Z1 board: